5
OPERATION / FUNCTION EDIT MODE
1. CHANNEL SELECT MODE
This feature allows you to select main channels to communicate with the party.
To access the Channel Select Mode,
-
Press the Function Button (#12) until “CH” appears in the LCD Panel (#8).
-
Press the Up Button (#10) or the Down Button (#11) to choose channels up or down from the current
channel
number.
-
Press the Enter Button (#13) to confirm your selection.
2. CTCSS (Coded Tone Controlled Squelch System) SUBCHANNEL SELECTION MODE
This feature allows you to utilize a less used channel range (00-38) within a main channel. This enables you to
communicate with another party on the same main channel using the same subcode. This helps to avoid
congestion on the main channel and filters out unwanted noise and static. There are 38 CTCSS subchannels
for each main channel.
To change the CTCSS subchannel,
-
Press the Function Button (#12) until the word “cTc” appears in the LCD Panel (#8).
-
Press the Up Button (#10) or the Down Button (#11) to choose the desired subchannel to use. The
corresponding subcode frequency will be displayed in the lower right corner.
-
Press the Enter Button (#13) to confirm your selection.
NOTE: To communicate with other PMR units, they must be switched to the same channel and CTCSS
subcode. To communicate with other PMR units that do not have subcodes, switch your unit to the same
channel with the subcode set to “OFF”.
3. AUTO CHANNEL SCAN MODE
This feature allows you to scan for an active channel and communicate with the party transmitting.
To access the Auto Channel Scan menu,
-
Press the Function Button (#12) until the auto channel icon blinks and “SC” appears in the LCD Panel
(#8).
-
Press the Up Button (#10) or the Down Button (#11) to choose scanning up or down from the current
channel number.
-
Press the Enter Button (#13) to confirm your selection.
-
The unit will begin scanning for an active main channel. If a transmission is detected, the Rx and RSSI
icons will appear in the LCD Panel (#8).
-
To turn off the auto channel scan feature in the standby mode, simply press the Function Button (#12)
once.
4. DUAL WATCH SCAN MODE
This feature allows you to monitor two different channels at the same time. If you pre-set any priority channel
other than the current channel in use, the pre-set channel will be scanned every 0.5 second and signals you
when a call is received.
To access the Dual Watch Scan menu,
-
Press the Function Button (#12) until the dual watch icon blinks and “dW” appears in the LCD Panel (#8).
-
Press the Up Button (#10) or the Down Button (#11) to select the desired channel number you wish to
closely monitor.
-
Press the Enter Button (#13) to confirm your selection.
-
To turn off the dual watch feature in the standby mode, simply press the Function Button (#12) once.
(32 paginas)
(124 paginas)
(36 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales